metric Joints & Drive Shafts

Belden metric universal joints are manufactured following the dimensions defined by DIN 808. All joints can be obtained with protecting boots, to avoid corrosion and to impede lubricant contamination. The metric universal joints are available in standard alloy steel as well as stainless steel 1.4305 (AISI 303). Additional corrosion protection can be offered by different forms of surface treatments. Standard options include black oxide, Zink and Nickel treatment. Additionally to the standard hubs, we can equip your universal joints with quick release ends, for simple mounting and demounting.

click on the photo for more info

metric Standard Joints

 

The Belden pin and block metric standard universal joint is manufactured from quality, high-grade alloy steel. The metric single universal joint can operate at angles up to 45° and metric double universal joints can operate at combined angles up to 90°. Metric dimensions following DIN 808 High-grade alloy steel Operating angles up to 45° Wide choice of hubs and finishes.

click on the photo for more info

metric Precision Joints

 

The Belden metric precision universal joints are pin and block friction bearing joints and are equipped with hardened bushings for increased endurance and reliable performance. They are available as single and double universal joint. Dimensions following DIN 808 Operating angles up to 45° for single joints and 90° for double joints. 

click on the photo for more info

metric Needle Bearing Joints

 

The metric needle bearing universal joint is made from high-grade alloy steel. It is equipped with needle roller bearings that allow operation at high speeds. The needle bearing universal joint is available in a wide variety of hub configurations and finishes as single or double universal joint. Dimensions following DIN 808 Operating angles up to 45° for single joints and 90° for double joints.

click on the photo for more info

metric Stainless Steel Joints

 

The metric stainless steel universal joint is made completely from 1.4305 (AISI 303) stainless steel and is equipped with friction bearings. The dimensions following DIN 808 Operating angles up to 45° for single joints and 90° for double joints.

click on the photo for more info

metric Drive Shafts

 

Our metric drive shafts can be developed from the metric universal joint to fit a wide range of applications. The overall length can be designed to the customer's exact specification. Custom drive shaft assemblies can be telescoping and spring loaded with a variety of hub end configurations to choose from.

click on the photo for more info

metric Boot Covers

 

Belden’s metric universal joint boot covers provide additional protection for the pins & block and also the needle bearings. If filled with grease the center components can remain lubricated and are covered and protected from dirt and debris. The boots increase the protection of the join especially in abrasive and corrosive environments. Available for all metric joints.

send email
Druckversion Druckversion | Sitemap
© PTMotion GmbH | Geneststr. 5 | 10829 Berlin | Deutschland